Display Case / Coffee Table

$125. Shadow Box Display Case or Coffee Table for Collectibles Original retail price paid was $798. Local pickup only. CASH Only. Open box (re-packaged) but never completely assembled previously, and therefore never used due to the following: There is a small scratch on the bottom panel. There is also a very slight indent and mark on the top of one of the side frame pieces (which is not visible once assembled) that looks like it may have perhaps been damaged at some point at the factory during fabrication, and then somehow overlooked prior to packaging/shipment since the slight indent and associated mark was already present and immediately observed upon removal of the shrink wrap off of this side frame piece. On the same side frame piece (which has the slight indent and mark along the top), there is also an issue with regard to affecting  the overall height of that side frame piece due to the location of the bottom 2 mounting holes for the attachment of the side lucite panel, as well as the location of the 2 pre-drilled holes in this side frame piece through which 2 hex bolts are placed, which needs to mate with (and screws into) the holes found along the side edge of the bottom panel. When trying to tighten the 2 bolts, I had to stop as I did not want to continue further since the bottom edge of the side lucite panel was apparently just a slight bit lower than it should be (in comparison to the other lucite panel that is mounted on the other end which does not have any issue), that was therefore preventing me from being able to fully tighten the side frame piece to the bottom panel due to the alignment issue of the 2 mounting holes between the side frame piece & the bottom panel, which was resulting in the bottom edge of the lucite panel to extend a bit too far down. Either minor sanding the bottom edge of the side lucite panel a bit, and/or slightly enlarging the 2 mounting holes on the side frame piece would resolve this issue. Once the alignment issue of the 2 mounting holes between the side frame piece and the edge of the bottom panel is resolved, it would no longer prevent the inside metal edge of the side frame from aligning properly with the bottom panel, thereby allowing the bottom edge of the side lucite panel to mate squarely as needed. The minor assembly modifications described above is why this item is listed for less than 1/4 the price that I had paid for it.

Condition

Open Box (never used)