1972 Chevrolet EL CAMINO SUPER SPORT SS With Allot Of New Rebuilt Parts

Up for sale is this project I've been working on I have a clean California title in my name registered none operational. 1972 El Camino super sport I've completed most of the work and have 97% of all the parts. 72 El Camino SS with bucket seats console floor shift tilt and round gage dash. All front and rear suspension has been rebuilt Up front it has new mooge inner outer tie rods center link drag link upper and lower ball joints Thicker front sway bar with urethane bushings and end links New carhex quick ratio 12.7.1 power steering box New booster New master cliynder All new stainless steel hard lines All new brake hoses front to rear New rotors new calipers new brake pads In the rear it has all new urethane using on boxed control arms with a rear sway bar and f41 braces 12 bolt with 308 gears not a posi it has new gear oil new brake hardware new brake shoes and new drums and wheel cliynders Most if not all front end parts and suspension parts are powdered coated It sets on a set of 15x8 corvette rally wheels with 245/60/15 I do have the trim rings and caps I have rechromed front and rear bumpers for it with powder coated brackets The motor is a 70 300hp 350 with 4 bolt mains and the rare 186 camel hump heads. It was just rebuilt by JMS racing engines in El Monte ca it only has break in time on the engine stand. We broke in the came set the timing and adjusted the rebuilt quadajet carb that was built by Mark at quadajet power . Com The transmission is a rebuilt th350 it has a new passing gear cable and new transmission lines. I have the drive shaft but haven't installed it because I want to put new u joints before I install it. The radiator water pump power steering pump is new or rebuilt Motor and trans sit on new urethane motor and trans mounts Headers are hooker headers that can use a paint job. It connects to a Flowmaster exhaust system with an h pipe. I have new m and h wiring for the front t engine and front lights the rest of the wiring looks okay. The bucket seats come with new correct 72 pattern covers that need to be installed. I have a new carpet for it. Not pictured but I have a set of doors off another car that are loaded with new door panels new weather stripping and other parts. I have a set of powerder coated inner fenders and a set of fenders with no rust that have the emblem holes for the ss I don't have a hood but I do have a set of powder coated hood hinges. It's an AC car I have most of the AC parts but the complete AC system needs to be rebuilt. I don't want to do it lol I've been working on it and will keep working on it if it dose not sell. I have most parts only thing I can think of that's missing is a hood. I can't decide on a cowlinductuon or just an SS hood This is a perfect project t for someone that wants a super easy to finish project most of the work is all done. At this point it's a perfect time to take it to get the paint and body work done. Than finish the rest. Asking $14,000.00 firm as it sits right now. I can finish and assemble it after you take it to paint and body for $17,000.00. I can also offer it as a runner for $16,000.00 in primer