1967 Buick Skylark axle and full assembly

1967 Buick Skylark 8.2” 10-Bolt Rear End – Cleaned, Primed & Painted – Rebuild Ready. The last picture is the car it came out of, which has been immaculately maintained. Due to low fluid after putting the LS swap in the rear end locked up on me, but we were only going 2 miles an hour right at Lauderdale By The Sea. So there was no damage other than the pinion bearing. Instead of rebuilding, I found a 72 Chevelle Posey track rear end to put in it instead.  Price: $450 OBO Location: Fort Lauderdale, FL ⸻ 💪 Description: Complete 8.2” 10-bolt rear end from a 1967 Buick Skylark (GM A-body). This rear end has been fully disassembled, thoroughly cleaned, and professionally prepped: • ✅ Housing fully cleaned, primed & painted • ✅ Differential cover (pumpkin cover) cleaned, primed & painted • ✅ Ring & pinion gears in excellent condition (no chipped or damaged teeth) • ✅ Carrier and internal gears are solid and clean • ✅ Axles, backing plates, and internals included ⸻ ⚠️ What It Needs: • Pinion bearing needs to be pressed out/replaced • Gear setup (lash/preload) during reassembly ⸻ 💬 Notes: • Fully cleaned inside and out — no sludge or buildup • Coated to prevent rust after cleaning • Turns freely look • Everything shown in photos is included 📞 Message Me: Serious buyers only — ready to go

Condition

Used (normal wear)