Auto meter Ultra lite Series 5" In dash Tach

Used auto meter tachometer ultralight series 0 to 10,000 RPMs 5 in diameter in-dash mount. The trim ring on the face bezel is a little dinged up but the tach works just fine. I had plans to mount it in a 64 Barracuda I have but it is just too large for the vehicle interior. It looks way out of place next to any of the original style gauges in the Cuda. I don't have the original wiring but I will provide you some 8 ft stranded copper 18 gauge color coded wire runs with the tack with the appropriate ends to hook to the tachometer head (female spade connectors) and a set of crimp on ring connectors for the ends of the wires you connect to the power, ground, signal (coil), etc. You'll have to crimp these on after you determine the correct length of wire to run to whatever circuit you are running. I'll also send along some heat shrink tubing to insulate the connectors at the point they crimp onto the wire. I don't have the wiring instructions anymore but they are readily available on line and I can provide you a link. The wiring I will provide for your installation will be the same as referenced in the factory wiring directions to avoid confusion when you are installing the tach. This thing costs almost $300 new. But like I said this unit has a few dings in the trim ring around the face. Also I don't have the original backlight assemblies and bulbs for the unit. It should be easy to round up something to fit the socket in the back of the unit. Personally I think I could live with the cosmetic flaws at a price of less than half of a new unit! I've used a photo editor on the pics I have provided here and way over done the sharpening adjustment and the contrast to highlight the cosmetic damage to the face ring. I'm sure I have made it look worse than it actually is in real life. Please take a good look at the pics.