Ryobi hpl51 3-1/4" Hand Held Planer

Power Source

Corded electric

Type

Planer

Brand

Ryobi

Ryobi hpl51 3-1/4" Hand Held Planer with a Spiral Cutterhead No Load Rotation Speed: 16,000/min Planing Width: 3-1/4" Rabbeting Depth: 7/16" Planting Depth: 0 to 3/32" Efficient Dust Extraction The spiral cutterhead provides the following advantages: * Smoother Finish with no tear-out. Each knife sits at a slight angle and produces a shear cut. Spiral cutterhead planes board in the staggered cut which is much better than a single straight cut. The combined shear and staggered cut eliminates tear-out and leaves a glossy surface finish on even highly figured hardwood. * Noise is hugely reduced as the spiral cutterhead allows a few knives to cut in a staggered way. * More than 10 times the life use of high-speed steel. The 15x15x2.5mm inserts are made of sintered tungsten carbide which is more complicated and harder than high-speed steel. Each insert has four edges. * Easy to change. The knives are precision ground to a tolerance of +/-0.0004" or +/-0.01mm and are interchangeable. Loosen the screw, rotate 90° for a new edge, and tighten the insert in minutes. It cuts your production time by 30%. * Dust extraction is more straightforward. The spiral cutterhead produces thinner and shorter chips. * Low cost to use. Spiral cutterheads produce a smoother finish, reduce or eliminate sanding work, and don't require sharpening, your products will pay for themselves in a short time.