Kenwood Car Amplifiers KAC-959 & KAC-819

Brand

Kenwood

I have 2 Kenwood amps for sale. I’ve held onto them for years waiting for the perfect vehicle to do a system in, but have decided it’s time to give up on that idea. The 5 channel KAC-959 has never been used and I still in the original box. The mono KAC-819 was used at one point years ago but hasn’t been hooked up in ages. Info about the amps was raked from the Crutchfield website. About the Kenwood KAC-959: If you subscribe to the "one amp to a car" philosophy, Kenwood's got the amp for you. The KAC-959 offers four 40-watt channels for your full-range speakers, plus a 120 watt mono amp for a sub (or two). Hooking up a single amp is much simpler than a multi-amp installation and, with this multi-channel marvel powering your tunes, you'll never want to get off the road! Kenwood throws in everything you'll need to run your system. Selectable high-pass (80, 150 Hz at 12 dB per octave) crossovers trim low frequencies from your front and rear speakers, while the sub channel features a variable low-pass filter (50-200 Hz at 18 dB per octave). A ground isolation circuit combines with extra-large noise filters to keep things dead-quiet. Kenwood amps deliver outstanding musical reproduction even at high volume levels. Details: 3-, 4-, 5-channel output Tri-way capable (Tri-Way crossover required) 60 watts x 4 + 170 watts x 1 at 2 ohms requires 4-gauge power and ground leads — wiring and hardware not included with amplifier variable (50-200 Hz) low-pass crossover, 18 dB/octave selectable (80, 150 Hz) high-pass crossover, 12 dB/octave 2 pairs of preamp inputs, plus one pair for subwoofer channel infrasonic filter at 15 Hz, 18 dB/octave speaker-level inputs 4-way protection circuitry signal-to-noise ratio 100 dB 11-7/16"W x 2-3/16"H x 12-5/8"D About the Kenwood KAC-819: The KAC-819 mono subwoofer amplifier was born to bring you loud, clean bass! Kenwood builds in MOSFET power supplies, extra-large capacitors, and copper-shielded EE core transformers to give your music impressive power output with minimum distortion. Sigma Servo (a negative feedback loop) uses a second set of speaker leads to your subwoofer for an ultra-high damping factor — you'll hear punchier, more forceful bass. A selectable infra-sonic filter (off, 15, or 25 Hz, 18 dB/octave slope) maximizes efficiency by eliminating bass below the range of human hearing. Pump up your low frequencies with the selectable bass boost (0, 6, or 12 dB at 90 Hz). Details: 230 watts x 1 at 2 ohms requires 10-gauge power and ground leads — wiring and hardware not included with amplifier frequency response: 5-200 Hz 50-200 Hz low-pass crossover, 18 dB/octave infrasonic filter (off/15/ 25 Hz), 18 dB/octave bass boost (off/6/12 dB) Sigma Servo dramatically increases amp's control over subwoofer MOSFET power switching supply speaker-level inputs signal-to-noise ratio 100 dB dimensions: 10"W x 2-5/16"H x 12-5/8"D