Engine Chevy 6.0 LS

I have a mildly built 6.0 Chevy LS with only 3000 miles on it. it started in a 2005 silverado. Asking 7000$ cash only. Willing to trade for a motorcycle. Let me know what you have. (Be aware i will not add cash on my end) *It's been bored .030 over * New 799 cast heads W/ Ls7 lifters and upgraded valve springs *Elgin cam (Sloppy Stage 2) don't remember specs off hand *Dimond racing flat top -2cc pistons *Manley 6.125 H-Beam rods * Stock crank that was ground and balanced by Tom's Performance in Vancouver *King racing rod main bearings *Jackspaininan low profile intakeW/92MM throttle body (cable not DBW) * Improver racing Crank scrapper and windage tray *Melling high-pressure oil pump *Summit racing wide sump oil pan *Accel 48lb injectors *MSD Coil packs *Ict Billet 4 corner steam port *Ict Billet Valley cover * ARP Main and head studs *Mishimoto 10 row oil cooler I have a stack of receipts to verify purchases, with the exception of pistons, coil packs, fuel injectors, and plug wires. The one issue is that one of the receiving holes for the starter bolts broke out, so the starter is only held in by one Bolt. That being said, I never had any issues with starter engagement. (It is fixable) I did mostly casual crusing, not a lot of high RPM driving The engine was assembled at Tom's Performance. It made 381 WHP on Wongs Mustang dyno. I have roughly 10,000 invested into the engine. I pulled the engine because my slave cylinder leaked and burned up my clutch . I have decided to sell it to fund a new project . The engine is on a stand ready to go. If you have any questions, feel free to ask.

Condition

Used (normal wear)

Brand

Chevy