Boat holds air but the floor peeled back in the front and a little bit in the back. I glued it back on with polyurethane boat adhesive but I didn't manage to get all the water leaks. It leaks slowly into the floor area but if you don't.put.a.lot.of weight In The boat then it's not bad and at max will only fill about an inch on the floor. With a big.motor the boat tilts back and the water sloshes to the back and can weight down the boat. If you plan on using it for just paddling then there should be no issue with keeping the boat flat on the water and then you will only.have wet feet. A tiny motor with one or two people may also be fine but with the floor taking in some water, it is best to use as a paddle boat. Comes with two professional paddles and paddle holders installed. Comes with all wood slat floor. The keel under the floor holds air but needs to be reattached in the front. Will work fine https://offerup.co/faYXKzQFnY?$deeplink_path=/redirect/. the leaks are slow so if you are handy you may be able to inject the leaky spots with adhesive to block the water from coming in but as is it's not well suited for a big motor. If you can fix the leak completely I believe it is good.for up to 10 horsepower motor so it definitely may be refurbished if you have some skill and patience. Or use as is on the river or lake as a paddle for the day. Since it has water leaks you wouldn't.want to just leave it inflated in the water for long.periods of time as the floor is made.of.wpod.and would eventually soak into the wood. To use for the day or the weekend will cause no issues but if you leave it floating.on The water for more than that, you could run into more issues. Works great for a floater or paddler or very small engine with weight distributed away from the rear. After gluing the floor.back together, I had to trim one of the wood floor slats to fit so the tip of the front wood slat is trimmed.back a little bit.