Condition: New Description: Each winch is equipped with a permanent magnet motor and is designed for intermittent duty general use. The winches are not designed to be used in industrial or hoisting applications and the manufacturer goes not warrant it to be suitable for such use. Free spool clutch is operated by a pull and turn knob which disengages the gearbox to allow the wire rope to be pulled out without using electric power. A tension plate reduces backlash and snarling when pulling out the wire rope. Operation: 1. Pull and turn the clutch knob to the "Off" position, so the drum can turn freely by hand. 2. Grab the cable assembly hook and pull the cable to the desired length by hand saver bar. Then attach to the item being pulled. WARNING: check that there are at least five turns of wire rope left on the drum before the operation. 3. Engaged the clutch by turning the clutch knob to the "in" position. WARNING: clutch must be fully engaged before winching, never engage clutch knob while the drum is turning, the clutch knob has been adjusted and permanently locked in place with a thread locking compound at the factory. Do not attempt to re-adjust the knob. 4. Push and hold the "cable in" button on the handheld and the cable was re-spooled. Push and hold the "cable out" button to reverse directions, wait until the motor stops before reversing directions. Re-spooling cable after the finished operation. Included (Item - Qty): 1. Motor - 1 2. Nut M6 x 20 - 4 3. Motor Base - 1 4. Nut M6 x 20 - 6 5. Coupling Joint - 1 6. Clutch - 1 7. T-series bushing - 2 8. Transmission Shaft - 1 9. Drum - 1 10. Tie bar - 2 11. Gear-box base - 1 12. Mounting bolt M8 x 20 - 4 13. Washer 8 - 4 14. Flat Washer 8 - 4 15. Nut M8 - 4 16. Flat Washer 10 - 2 17. Spring - 1 18. Lock Washer - 1 19. Left gearbox - 1 20. Right gearbox - 1 21. Gear 1 - 1 22. Gear 2 - 1 23. Gear 3 - 1 24. Central gear - 1 25. Nut M3.5 x 6 - 1 26. Bracket - 1 27. End cover - 1 28. Nut M6 x 55 - 3 29. Clutch handle