Seven Cycles Axiom Steel Frame 56cm With Dura-ace 9100

Seven cycles steel frame axiom bike. Tons of high end parts, its ready to go, zero mechanical issues. When i got this bike it was painted all grey, it was stripped down to raw steel then clear coated. One section of the clear coat flaked off and had to be redone. It is noticeable, on the under side of the top tube by the seat post. There are 2 other small blemishes, the rear brake cable stays have some rust, and the down tube has a very small dent. I was quoted $185 to replace the brake cable stays by R.E. cycles in seattle. It will require the frame to be stripped back down and recoated, but at that point it can be painted in any color you want, or re-cleared to keep this same look. Front fork is and enve carbon. This bike is setup "RIGHT SIDE FRONT BRAKE" please keep that in mind, i rode motocross and thats how every motorcyle is. Complete shimano Dura ace 9100 11sp group set with a ceramic speed idler set up. The crank is the 9100p 50/34 with the built in power meter version and i have the $60 charger cable for it too. Along with the rear cassette 12/27. I will confirm crank arm lenth. I think its 172.5 Chris king bottom bracket and headset Profile design 38mm carbon clincher with yellow swiss stop pads. Both wheels are true on a set of KCNC ti skewers Zero set back thompson masterpiece seat post Easton EA 90mm stem and EC70 42cm carbon bars As it sits, it's about 17lbs. Could be lighter with a different seat, tires and tubes. These are about the only heavy parts on it. This bike is dialed and ready. Im sure im forgetting some things as well. Asking $1400 obo with the DT swiss 1800 wheelset or $1800 with the profile design carbon's Will consider partial trades for gym equipment and quality golf equipment, launch monitors, transferable freedom things if you are into that.

Condition

Used (normal wear)

Frame Size

56-58 cm

Wheel Size

29 in / 700c

Frame Material

Steel