Waste my time in any way and Im just gonna block you from my posts. Ok, so Im selling a good Kenwood 2 channel amp. Amp works perfectly. I had it pushing an Alpine Type X 12" sub (on 1 coil cause they're 1000 rms subs) and it did just fine. This is a very good and reliable amp and yes, I can/will hook it up to show you it works. Just dont need this one as I have enough amps for all my builds in my rides. To be clear, I AM IN NO HURRY to sell so, lowballers just move on to a different post. Im asking $140, but I am open to real offers. I will reply to everyone accordingly. Im only selling to get myself a jetski stand/cart thats posted on here. They average in similar price Or will trade if you have one, but must be set up for or adjustable for bigger sit down skis. Not looking for one for stand up skis. Specs on amp are...... 500 RMS 1000 MAX 8 gauge wire, but I used 4 gauge just fine for better power supply. Full specs below. 2-channel car amplifier 170 watts RMS x 2 at 4 ohms (250 watts x 2 at 2 ohms) 500 watts RMS x 1 bridged output at 4 ohms (4 ohm stable in bridged mode) CEA-2006 compliant high-pass (12 dB per octave) and low-pass (24 dB per octave) filters variable from 50 to 200 Hz cooling fan MOSFET power supply Tri-way capable (Tri-Way crossover required) preamp- and speaker-level inputs preamp outputs fuse rating: 40A x 1 8-gauge power and ground leads recommended — wiring and hardware not included with amplifier 14-7/8"W x 2-3/8"H x 11-9/16"D