Selling for a friend in need. He has done a LOT of work on it and has parts to do more, just not the time! Engine looks CLEAN!! Please make a REASONABLE OFFER!! No low ball offers will be considered, I will simply say, "Thank you for your interest, but your offer is too low."! Please read details!! **A LOT OF WORK HAS ALREADY BEEN COMPLETED!! (Will provide a list of what has been done and what needs to be done.) Many of the parts necessary to complete the project have been purchased, but just haven't had the time to put them on. Parts are included!!) Everything on this list is new : Brake master cylinder Brake booster Brake calipers Brake rotors Brake pads Remanufactured Heads Lifters Push rods Timing Chain Ignition coil pack Fuel injectors Fuel pump Fuel pressure regulator Camshaft position sensor Oil pump Oil pick up tube Spark plugs Spark plug wires Rear main seal Front main seal Egr valve Dpfm sensor Serpetine belt Water pump Idler pulley Tensioner pulley Starter Torque converter Evap valve What needs to be done: I have all new oxygen sensors that need to be installed. A new front y- cat that needs to be installed. Broken bolts will need to be removed from the exhaust manifold in order to install the front y-cat. The rear cat will need to be attached to the front cat. Then the muffler needs a coupling to attach to the rear cat. The passenger side head gasket needs to be redone (wasn't done right). The transmission bell housing has a crack and I tried patching it temporary with JB weld but should be replaced eventually. I also never replaced the crankshaft timing sensor( part is still good) **Also have a PROJECT boat and trailer for sell. WILLING TO MAKE A BUNDLE COMBO DEAL!!!