2003-2006 Toyota Tundra (4 Door Only) Heavy Duty Front Bumper. Might fit 2001-2007 Toyota Sequoia, no guarantee. Asking $800 This is the Defender 4 series with two light tabs. Has mount for a winch. New cost- $1700 Had some scuffs that touched up. Dealer info- IRON BULL'S BASE BUMPER Our base bumper, standard features include, four five inch Round light hole buckets or two five inch Round light hole buckets (depending on your model), a winch plate to mount any winch you want and our "welded through" d-rings to mount any 3/4" shackles. (Lights, winch, and shackles not included with our bumpers) When we say "welded through" we mean a slot is cut in the front plate and the d-ring is inserted and welded on the inside and out. We are the only company that does this. Other bumper companies just put the d-ring on front plate without cutting a slot and weld it once on the outside of the bumper. Our base bumper is constructed from a sheet of 3/16" plate steel, each piece cut out as its' own, so there is no press braking to ensure maximum strength. Then each piece is jigged into place and fully hand welded from the inside, out, grinded to a smooth, but strong finish then coated with our "Black Shield" coating. We take the extra time to fully weld our bumpers unlike other bumper companies that press brake most of the bumper and stitch weld in only a few places, our bumpers are made to be used and abused not just to look pretty. Most bumper companies use powder coating or liquid paint as a finish on their bumpers, but we are the only ones to use what we call our "Black Shield" coating it is a premium bed liner like Rhino lining ® or Line-X ®. Unlike powder coating and liquid paint "Black Shield" will not chip off or crack from rocks, instead our coating repels the rocks. Just as we said before our bumpers are made to be used and abused not just to look pretty. (To learn even more about our paint check out our "paint" page) Pictured below is an example of our front base...