Healthbond 2399 Pressure Sensitive Adhesive

I have around 6 buckets new Buy more then one or all six and you'll get a better deal Healthbond 2399 Pressure Sensitive Adhesive Healthbond 2399 is a high strength pressure sensitive flooring adhesive specifically designed for interior releasable installation of Bentley EliteFlex 6 ft Hardback, EliteFlex 6 ft Cushion, AFIRMA II Hardback Carpet Tile, NexStep Cushion Tile, Luxury Vinyl Tile (LVT) and modulyss Carpet Tile. The dried adhesive will remain on the floor, allowing individual carpet tiles to be lifted out and replaced without substantial loss of adhesive properties. This product is an aggressive pressure sensitive formulation that retains its tack for the bonding to various substrates. The dried film is alkali, water, and plasticizer migration resistant. This adhesive can be applied using common tools and techniques over a variety of porous and non-porous surfaces. Healthbond 2399 is a water-based, solvent-free, non-flammable, and low odor adhesive. It also has very low VOC’s, which makes it ideal for use in schools, healthcare facilities, public buildings, and anywhere indoor air quality is a concern. Healthbond 2399 is Carpet and Rug Institute (CRI) Green Label Plus certified and may contribute to LEED project certification for low emitting materials. This adhesive meets or exceeds California requirements as specified in Rules 102 and 443 as well as SCAQMD Rule 1168. APPLICATION INSTRUCTIONS: Site conditions, floor preparations, moisture and alkalinity must comply with those specified by the CRI 104, Standard for Installation of Commercial Carpet. The installation site, flooring materials and adhesive must be maintained at 60°F - 90°F (15°C - 32°C), and the humidity between 30%-60% for 72 hours prior to, during, and after testing and installation USE OVER: Wood: APA approved flooring grade plywood, or hardwood installed to manufacturer’s specification. Concrete: Substrate must be structurally sound, clean, flat, and dry. Remove all foreign substances that would interfere with a good bond. Fill all holes and cracks with a cement based patching compound and sand high spots. No RH Testing required; No pH testing required; No verifiable intact vapor retarder required on Bentley carpet tile and EliteFlex products. (Not applicable for modulyss and LVT). Resilient Floor Coverings: Not recommended for direct use over existing sheet vinyl, laminate solid vinyl tile, or rubber flooring. Use of this adhesive over vinyl asbestos tile or vinyl composition tile is acceptable when all finishes, including waxes and sealers have been removed. Not recommended for application over old cut-back, bituminous or petrochemical based adhesives. Cannot be used over chemically cleaned subfloors. Note: It is the sole responsibility of the contractor/installer to determine the proper porosity of the subfloor, apply the proper amount of adhesive, and ensure that all instructions, procedures, and practices are strictly adhered to. Gypsum or dusty substrates will require an approved primer.