Dynaco Stereo 400, Power Amplifier, Perfect Working Condition.

Perfect with an audiophile amplifier, McIntosh, Bowers & Wilkins, audio research, Marantz, Sansui, JBL, ALTEC, Tannoy, pioneer, Adcom, Krell, Martin Logan, Klipsch, audiophile stereo kenwood, Bogen, HH Scott and The Fisher. For sale is Dynaco stereo 400 power amplifier, all the functions are working as should, both channels sound really sweet, Description The Dynaco Stereo 400 is a basic power amplifier employing all silicon solid state devices. They include 46 transistors, 47 diodes, 2 silicon controlled rectifiers, and 4 integrated circuits. The series-connected output circuitry is of full complementary symmetry design. The entire main amplifier is direct coupled. It's measured distortion levels approach the threshold of the most exacting laboratory test equipment, not only at the commonly specified full power ratings, but more importantly at very low power outputs as well. This is the result of circuit techniques which eliminate any discernible crossover notch at low levels, and it contributes in large measure to the Stereo 400's freedom from listening fatigue. It's lucid, utterly uncoloured neutrality reveals delicate nuances and musical shadings in the best program material - one result of achieving unconditional stability with varying loudspeaker loads. Implicit in the design of a superb high power amplifier is the responsibility to include superior techniques of protection for both the amplifier and the speaker load, if long-term trouble free operation is to be achieved. To this end, Dynaco has included more separate protective systems and features than have ever been employed in such a product. These include an AC line circuit breaker (rather than a fuse); four separate power supply fuses; electronic volt-amp limiting to ensure safe operation of the output transistors; independent high temperature cut-outs on each channel, which are mounted directly on the output transistors to assure maximum sensitivity; over 1000 square inches of radiating area for the mammoth heat sink; provision for accessory fan cooling with optimum efficiency; delayed turn-on to eliminate loudspeaker thumping; relay protection against DC signals at the output; load (speaker) protection fuses accessible on the front panel; input level controls to reduce sensitivity; input filters to control the bandwidth; and the exclusive Dynaguard adjustable dynamic power limiting circuit to protect the speaker load. The Stereo 400 was engineered to accommodate a wide range of specialized needs in studio, laboratory and industrial applications, as well as in the home. It has been designed as two independent 200 watt (at 8 ohms) amplifying channels with a common power supply having a high degree of inherent regulation. For special requirements, a technician can easily convert it to a monophonic 600 watt (at 8 ohms) output. Accessory provisions for mounting on a standard 19 inch rack, an alternative front panel which includes two output meters, a cooling fan, and an alternative power transformer for international AC line voltages are available at additional cost. Specifications Power output: 200 watts per channel into 8Ω (stereo), 600 watts into 8Ω (mono) Frequency response: 20Hz to 20kHz Total harmonic distortion: 0.25% Damping factor: 30 Input sensitivity: 1.6V Signal to noise ratio: 95dB Speaker load impedance: 4Ω to 16Ω Semiconductors: 46 x transistors, 47 x diodes, 2 x silicon controlled rectifiers, 4 x IC Dimensions: 17 x 14 x 7 inches Weight: 52lbs Thanks for watching

Condition

Used (normal wear)

Model

Stereo 400

Brand

Dynaco

Playable Media

Power amplifier