Vintage Sanyo DCX-3500k stereo quad receiver

For sale: Vintage Sanyo DCX-3500k Stereo Quad Receiver $85 Nice sounding Sanyo DCX-3500K stereo/quad receiver. Warm rich sound out of this receiver. Cleaned pots, tested AM/FM, A and B speakers output, phono and aux. Well rounded good working unit. It does have a few lights out in the two left meters (A and B left channels) and one or two out in the FM dial. Wood veneer on the case shows some wear on bottom edges (the unit had no feet when I picked it up). I've added feet since. Good for a quick fixer-upper unit by adding lights or you can simply use it as it is. Xposted, will meet for pickup. Will ship for out of state buyers. Technical details below: This unit is set up to play all known 4-channel method. It contains SQ matrix decoder and CD-4 circuits, Quadro records after CD-4 process can be reproduced without any additional decoder. The power amplifiers can interconnect for 2-channel stereo operation unpick or 4-channel mode. The high output power (100 watts) and the advanced circuit design give even in conjunction with speakers low efficiency of an outstanding performance. Other special features include: four level controls, for each channel, selectable 2 - and 4-channel tape recorders and turntables for ceramic or magnetic system. Furthermore, tape monitor and loudness switch. Stereo audio disks and tapes can use the matrix decoder circuit are shown pseudo-quadraphonic. Future FM four-channel broadcasts are decoded in the matrix circuit SO and can be taken with a 4-channel tape recorder and replayed. Specifications Quadro / stereo receiver DCX 3500 K AMPLIFIER SECTION Music Power (IHF) all channels driven 4-Channel 100 Watt 8 Ohm, 160 Watt 4 Ohm 2-channel: 80 Watts 8 ohms Sinus rated 8 ohms each channel in 4-channel mode: 20 watts x 4, 2-channel: 30 watts x 2 Power Bandwidth 20-50000 Hz THD less than 1% at rated power Frequency Response 18-50000 Hz Input sensitivity and impedance PHONO (kOhm 50) 5 mV AUX 200 mV (100 ohms) Tape Playback: sockets 300 mV (100 ohms), DIN 300 mV (100 ohms) Band connection-receiving sockets 180 mV (10 kOhm), DIN 50 mV (50 kOhm) Tone controls Bass +8 / -10 dB at 100 Hz, Treble +8 / -10 dB at 10 kHz Frequency contour +7 +7 dB dB at 100 Hz at 10 kHz FM RECEPTION PART Reception 88-108 MHz Sensitivity uV 2 THD less than 0.8% Signal to noise ratio better than 65 dB MONO, STEREO better than 55 dB Selectivity better than 40 dB Image rejection better than 45 dB IF rejection better than 75 dB Stereo separation better than 33 dB MW HOME PART Reception 535-1605 kHz Sensitivity 15 uV Image rejection better than 40 dB IF rejection better than 30 dB Selectivity better than 40 dB GENERAL DATA Semiconductor 1 FET, 8 IC's, 51 Tr, 30 diodes Power supply AC 120/200/220/240 V Wattage 175 W Dimensions (W x H x D) 526 x 165 x 370 mm Weight 11 kg