Onkyo INTEGRA DTC-9.8 THX Ultra2 7.1 SSP And DTA-9.4 Amplifier

Known as “The Cadillac of theatre systems, this system cost $5500 new and literally has less than 20 hrs of play time. Multi-Channel Power Amplifier from Onkyo / Integra model # DTA-9.4. Rated Power @ 8-ohms is 120 watts per channel. When New, this Amplifier had a retail selling price of $3000.00. I use for my 4 Dolby Atmos channels but since I've got McIntosh amps for my main channels, I'm looking to replace this with a vintage McIntosh amp for an all McIntosh amp setup. The receiver- Balanced inputs and outputs, something only seen in boutique brands. ◊ Includes top notch video processing (HQV Reon-VX) usually only found in very expensive separate video processors. ◊ Speaker setup a no-brainer with the Audyssey MultEQ XT (includes the mic). ◊ Has four HDMI inputs and two HDMI outputs so you can drive a second display in the room (although not both at the same time). ◊ HDMI 1.3a supporting all of the current Dolby and DTS formats (yes even DTS-MA). ◊ Top of the line 24/192 kHz Burr Brown DACs on all channels. ◊ Measurable performance, not just marketing hype (see our On the Bench section). ◊ Decent looks in a heavy chassis something that means a lot in terms of perceived value for your dollar. ◊ THX Ultra2 Certified (As Brian Florian would explain, this is important, if for nothing other than peace of mind). ◊ RS-232 and Ethernet control for custom installer. POWER AMPLIFIER 7 Amplified channels: 120W per channel into 8 ohms measured at frequencies from 20Hz to 20kHz and THD 1% Power output: 240W per channel into 4 ohms measured at frequencies from 1000Hz to 1kHz and THD 1.5% 10 - 60kHz at +-3dB Frequency response: 115dB Signal to noise ratio: Balanced: 10 kohms, Unbalanced: 5 kohms Input impedance: : 1V Input sensitivity: over 25 at frequencies from 1000Hz to1kHz at 8ohms Damping factor: High-current power Features: CONNECTIVITY Unbalanced (RCA): 7, Balanced (XLR): 7 Inputs: Binding post terminals Speaker connector type: Banana-plug compatible 12V Trigger BODY 17.13 in x 6.88 in x 17.81 in Dimensions (WxHxD): 39 lb Weight: POWER Standby: less than 3.8 W Consumption: 120 V Power adapter voltage: 60 Hz I have several high dollar speaker’s (30) from small to big, I can include but the price will go up per set. I want $800 for the receiver and amp. If I need to sell separate I will.