1989 Alumacraft Trophy 170

Year

1989

Engine Type

Single Inboard/Outboard

Model

Trophy 170

1989 Alumacraft Trophy 170 140hp boat with 1987 Shorelander Shorelandr galvanized trailer and tons of extras. Great boat for fishing or touring. Nice simple, cheap, easy to service, long lasting design. Not dealing with tire kickers who don't know how to recognize a great value. This boat will need far less work than most. $4500. Absolutely no trades. Cash only. I have Title for both the boat and the trailer. You won't have to worry about that at all. No problems getting registration like you will have with many others here. Won't take much to get this running and on the water again. I hoped to have time for it and that just isn't happening for me so time to sell it. Was preserved well. You'd be hard pressed to find one this nice especially with all the extras I am including. The rot you typically see on transoms and engine mounts is nowhere to be found here. This is a gem. Look at the outdrive, prop, etc. Last work was pulling the tank from the floor to fix a fitting for the gas line. Got the tank in there and that's where I stopped. 3.0L 4 cylinder 140hp engine with the Cobra Stern drive. This boat has very few hours on it but there is no hour meter. Also included is the Montgomery Ward Sea King Outboard Engine 7.5hp mounted to CMC Power Tilt and Trim. Just the PTT is over $600. You will need new tires for the trailer to be able to take this away as the present ones are too far gone. Tire Size ST175/80R13 5 lug. You'll also need new batteries so bring one to raise the drive. This boat hasn't been used recently but was stored under cover in a barn most of the time. Not ready to start in present condition as the gas tank isn't hooked up and need a line there. Feel free to inspect the outdrive and engine and linkages but everything had no problems at all last it was used. Fluids were changed before it was put in storage. It hasn’t been in the water a few years but all oils were changed before storage plus fogging oil in cylinders through plug holes. It’s all great. Lots of extras will be included that aren't pictured and no time to list. Center Line Length 16' 10" Maximum Depth 39.5" Width 79" Transom Width 73" Available H.P. 140 Hull Gauge Bottom .080 Hull Gauge Sides .080 B.I.A. Capacity 960 Approx. Weight 1725 Hull Style Deep Vee

Make

Alumacraft