Miscellaneous Lumber & Supplies (from DIY Pull-up Station)

I built an I door pull-up tower last year and am selling all the supplies I used. Overall this cost me about $125 I think. Below is a list of the items… 4x4 Prime Douglas Fir (24 ft total) - 2 x 48” - 2 x 96” 5/4 x 6 Premium Southern Yellow Pine Pressure Treated (about 16ft total) - 3 x 46” (angled end cut) - 1 x 48” unused 4 @ 4x4 strong tie post caps (still connected to the 4x4s) 1x4 common board (12 ft total) - 2 x 56” - 2 x 17” 1 x 48” Black Pipe w/ 2 floor flanges (still connected) I also have a 19” 6ft panel (SPF Spruce Pine Fir laminated) from another project that I’m including. It’s been cut into four pieces… - 3 @ 19”x12” - 1 @ 19”x36” I’m including the metal straps, screws, and washers that I used. I think I have more screws and hardware if you want to buy those as well. The pull up station was not very sturdy which is why I was using bags of concrete mix and 40lb dumbbells to stabilize it. You could try and reassemble everything and use it for pull-ups but I probably wouldn’t recommend it, unless you added some additional weight at the base. The 4x4s were too light it turns out. But you can have the concrete mix bags if you want, I have no use for them. There’s a little splitting in the 4x4s but are still strong and can be useful for a home project. Also, I have a van and can deliver all of this. Make me an offer! Let me know if you have any questions, thanks!

Condition

Other (see description)