Brand new the plastic bottle in the back of it was broken in the transportation but it has been glued. Special price $1399 Oxygen injection facial care Attack effect: Inject more than 98% pure oxygen and active ingredients into the basal layer of the epidermis, improve skin metabolism, renew damaged cells, increase skin elasticity, improve dull and dull skin with pigmentation, slow down skin aging, and provide sufficient oxygen , Beautiful skin. Steps: 1) Use the skin detection handle to detect the skin condition, 2) Clean facial skin with cleanser. 3) Thoroughly clean the skin, this step should be used in conjunction with the use of shovel to remove aging keratin and deep dirt (10 minutes) 4) Use a micro bubble pen to clean the facial water circulation, holding the pen and moving it along the skin. (15 minutes) Wipe clean the face with warm water. 5) Spray oxygen with oils. Take 2-3 drops each time and dilute with water. During the oxygen spray process, cooperate with the technique to improve. (15 minutes) 6) Oxygen injection, apply the essence on the face, and use a pressure nozzle to perform neck massage, lifting, wrinkle removal and other techniques along the skin texture of the neck to inject oxygen. (15 minutes) 7) Use BIO skin lifter with oils to lift the neck, reduce neck wrinkles, and reduce muscle sagging and sagging. (15 minutes) 8) Apply a facial mask, put on an oxygen mask, and do oxygen-scenting care. (20 minutes) 9) Use a cold hammer to soothe and calm the skin Operation precautions 1. If the water circulation of the micro bubble head is interrupted, please check the following points: a. Whether the air pressure is well adjusted; b. Whether the catheter is intact and whether it is blocked. c. Whether the sealing ring of the probe is clamped; d. Whether the water supply in the water inlet cup is sufficient; 4. Ultrasonic handle: Use the energy increase button to adjust the energy to 10 grids, and warm up for 20 seconds. The energy can be accepted as a suitable gear with the person being cared for. The upward lifting method shall prevail, and the line shall be the same as above. (The half face treatment time is 5 minutes, and the gear will be reset to zero after the operation) 5. Cold hammer: first start the work area, then use the energy increase button to adjust the energy to 10 grids, pre-cool for 5 seconds, and then first test the temperature on the operator's hand, add or subtract according to the guest's adaptability, the operation method is the same as above Return the energy to zero after the operation (operation time is 5 minutes for half of the face) 6. Ion eye pen: First select the BIO working area, and the energy will be strengthened from the first gear. When treating the eyes, it can be operated together with the facial decree lines, and the lifting technique is used. When the eyes are treated, because of the contact surface The smaller the energy, the stronger the energy. Remember: When acting on the upper eyelid, it must not be used on the eyeball part, and should be operated along the brow bone. (Single course of treatment, one eye operation time is 5 minutes, then the energy is returned to zero)